Prev
Next
Forums Integration / Customization IPA/ProcessFlow

LPA scheduled flows

 7 Replies
 0 Subscribed to this topic
 52 Subscribed to this forum
Sort:
Author
Messages
Gary Padgett
Veteran Member
Posts: 90
Veteran Member
1/6/2014 4:36 PM
    I have set up several flows to run once daily.  Some are supposed to run at night, some in early morning.  It looks like the first iteration of each of these ran when it was supposed to, but all subsequent runs are running at midnight.  I am sure I missed something in my schedule setup, but I don't know what.  Can someone provide a little guidance?  Thanks in advance.
    BarbR
    Veteran Member
    Posts: 306
    Veteran Member
    1/6/2014 4:53 PM
      If you are still on PFI (we're on 9.0.1.10) You have to defined the time in two places.
      The first under the "First Run Date and Time" - and you must select the time BEFORE you select the date. The second is the "Start Time" where you pull over the desired time from the Available Hours and then adjust the minutes in the box above it.
      If those check out okay you might just want to delete the schedule and create it new (there may have been corruption when it was added to the LOGAN table).
      Gary Padgett
      Veteran Member
      Posts: 90
      Veteran Member
      1/6/2014 4:57 PM
        No, this is LPA not PFI.
        BarbR
        Veteran Member
        Posts: 306
        Veteran Member
        1/6/2014 5:02 PM
          OK, I don't know if those still write to the LOGAN tables? If so, looking at that might provide a clue - what does the recurring_opt field on the logan.wfjobdef table look like for that job_id?
          Bob Canham
          Veteran Member
          Posts: 217
          Veteran Member
          1/6/2014 5:18 PM
            When you scheduled it in IPA, what frequency did you choose? If you used By Day, make sure that after clicking Next, that you choose the Hour to run it under "Year and Specific Time to Run Action". That is what controls the time of day that the flow runs.

            Also, you should be able to find your scheduled task and see the next 3 run times under your My Actions in the rich client.
            Erin
            Advanced Member
            Posts: 24
            Advanced Member
            1/6/2014 5:20 PM
              Gary,
              That happened to us. We had to set it up in military time separately from the initial run.
              use Advanced Schedule Options

              FYI we are on

              IPA Product Version: 10.0.4.2..5772

              Gary Padgett
              Veteran Member
              Posts: 90
              Veteran Member
              1/6/2014 5:39 PM
                Thanks, Bob and Erin. I will make these changes and check it again tomorrow. Will report back.
                Gary Padgett
                Veteran Member
                Posts: 90
                Veteran Member
                1/7/2014 9:11 PM
                  Yes, looks good - thanks